Page #22

INSTALLATION MANUAL

STEP 6: PAGE 2 OF 3

DIAGRAM 6.2

When the Front wall is plumb, secure the Weatherguard Roof Panel to the Header Beam. This is done by measuring the overhang of the roof from the plumb front wall on the underside of roof to the Header Beam Add 3/4" to this measurement and mark the top side of the roof, 4" from the seam edge,(there should be a screw 4" on each side of the seam joining the roof Panels) this measurement will give a strong bite into the Header Beam but will not penetrate the electrical raceway in the Header Beam. Secure the Weatherguard Roof Panels to the Header Beam with 4" lag screws with washers attached, (4" roof will require 5" lag screws) finish securing the roof panels with screws 12" on center.

DIAGRAM 6.3

The next Weatherguard Panels tongue and groove should be cleaned and free of oil and dust. The tongue side that mates with the first Panel should have silicone applied to the top of the tongue. This is to ensure a weathertight seal after interlocking the panels together. This will also seal the roof with a seal that is not exposed to the UV rays of the Sun.

DIAGRAM 6.4

Place the second panel, parallel to the first, 3" from the Attachment Channel and overhanging the Header Beam. Tilt the panel up and push towards first panel until the top of the panels are interlocked. Slowly lower the panel until the bottom of the  tongue & groove are interlocked. See Diagram 6.5 Now push the second panel into The Attachment Channel and secure the panel to the Attachment Channel. Plumb the wall module under the second roof panel and secure the roof panel to the Header Beam. Repeat this process for the remaining Weather guard Roof. Seal all of the Weatherguard seams with a small bead of Silicone, for a second weathertight seal. Seal the top junction of the Weatherguard Panels to the outside lip of the ,Attachment Channel. Seal all of the Weatherguard seams with a small bead of Silicone,for a second weather tight seal. Seal the top junction of the Weatherguard Panels to the outside lip of the Attachment Channel.